Reset Your ReoLink Camera by Pressing the Reset Button
You can reset your Reolink camera by pressing the reset button. It all depends on where the reset button is located.
- ReoLink Wi-FI and PoE Cameras: For Wi-Fi and PoE cameras by Reolink, press their reset button then hold on. Afterwards, power on the camera while still pressing the reset button. Hold the reset button for about 10 seconds before releasing it.
After reset is done, the camera should return to factory or default settings. Just login with the default username and password to setup the device anew.
- ReoLink Keen and C Series: In order to reset Reolink Keen, C1, C1 Pro, C2, and C2 Pro, press and hold for about 10 seconds before release. The cameras will give reminders of the reset if done properly. For Keen, it will sound the prompt, “Factory Reset Succeeded”.
For C Series cams, it will start to pan and tilt. Use the default username and password after factory reset.
- ReoLInk Argus Series: In order to reset Reolink Argus, Argus 2, and Argus Pro insert a needle into your camera’s reset hole then press and hold for several seconds until you hear the prompt of “Factory Reset Succeeded” or beeping.
This means your camera has been successfully put back to default settings. It’s the same deal with Argus Eco, but the prompt is instead a short beep music or the words, “Please release the reset button”.
Argus PT has the same prompt as Argus Eco, but this time you need to rotate the lens to access the reset hole.
- ReoLink E Series and ReoLInk Go: To reset the Reolink Go, insert the reset needle into the reset hole and press and hold for 3-5 seconds. Release when you hear a short piece of music.
It’s the same when resetting the Reolink E series cameras such as Reolink E1, 3MP/4MP/5MP E1 Pro, E1 Zoom, and so forth. A single press leads to a soft reset while more than 5 seconds results in a hard reset to factory settings.
https://oursecurelife.com/